Creality K1 Vs K1c. Hi, i’m trying to import my custom filament profiles to creality print 5.1, but can’t find the option to do it. I see a lot of problem statements in the forum therefore i would like to share my best practice so you can benefit from it.
Hi, i’m trying to import my custom filament profiles to creality print 5.1, but can’t find the option to do it. My k2 has been sitting idle for 3+ weeks now, with the extruder motor presumably dead. I print via usb, however don’t see a way to select usb printing…just says lan.
K2 Plus Recommended Filament Parameters 1.
I had 200+ rolls of different filament from. Welcome to the creality forum…! I see a lot of problem statements in the forum therefore i would like to share my best practice so you can benefit from it.
Also Don’t See Any Option To Create A New Filament Profile.
Looking fir things to do (and not do) to ensure adhesion and good turnout and easy support removal on. Just out of curiosity why are you connecting with usb and not wireless…? It doesn’t rotate at all and it happened right after it started reporting problems with the.
It Is Recommended To Dry The Filament.
[tc2841]cutter issue, cutter might be jammed, please try again after.
Images References :
Welcome To The Creality Forum…!
Hi, i’m trying to import my custom filament profiles to creality print 5.1, but can’t find the option to do it. My k2 has been sitting idle for 3+ weeks now, with the extruder motor presumably dead. Also don’t see any option to create a new filament profile.
It Doesn’t Rotate At All And It Happened Right After It Started Reporting Problems With The.
Introduction to key filament process parameters 2. Find the best z offset using ‘expert mode’ on your creality hi, and write it down (mine is 0,2). K2 plus recommended filament parameters 1.
[Tc2841]Cutter Issue, Cutter Might Be Jammed, Please Try Again After.
Then open creality slicer, on the left corner you’ll find the name of the printer. I hear it’s not easy. Hello, i installed the cfs upgrade for the k1c, now i have the problem, evertime that my printer screams:
Just Out Of Curiosity Why Are You Connecting With Usb And Not Wireless…?
It is recommended to dry the filament. I had 200+ rolls of different filament from. I print via usb, however don’t see a way to select usb printing…just says lan.
I Am About To Try Petg On The K2 Plus For The First Time.
I selected that i have an ender 3 s1 pro in the setup, but it wants the ip address. Looking fir things to do (and not do) to ensure adhesion and good turnout and easy support removal on. Creality print provides an array of tested and official print configurations, encompassing aspects like printers, filaments, and process settings.